I have a league table of iron bent at a falling tree. Is it possible to turn back?
It's just a little bent, but is iron. I tried to write a little, but no luck.
His ability to restore the original position of the metal components depends on how bent, and the techniques used to restore it. There is a characteristic of metals requires that any bending [Original or restoration] is that the metal must bend "a little further (beyond) "that wherever they are. This is due to" spring "in the metal. To illustrate the technique, confine myself to a single steel rod. The same principle applies to multiple adjacent bars. It seems his "hammer" probably because they all failed attempts what the fight was not enough. It is preferable to use sled 8 or 12 Pound Hammer or maul. This will overcome the resistance of the metal. In response to proposed turn the table upside down, preferably in a concrete driveway or sidewalk. In the case of a hammer or pound on an object lying on the grass or soil, the energy of his hammer is absorbed into the soft material. Moreover, for metal bending "slightly" beyond where you want to finally use some blocks of 2×4 wood waste out under the twisted metal to each side [but far from] the focal point of the curve you want to correct. This allows the metal above the hard surface and allows the center of the curve moves slightly beyond the plane of the starting position. So with a heavy maul or sled dog, the book, precisely the midpoint of the curve. Start with gentle strokes reletively, bend the metal a little at a time to prevent overbend. If the light moves do not cause any movement, then slightly increase the force of the blows until the metal begins to move slightly. Do this until the bar is bent back to where you want. Considering that probably more bent bars, and the other bent, it will be difficult make the bar that you work to move all the way, you should work every bar a little at a time. The work of the first bar until it moves a little, then work in the next and the next day and the next, then the other direction. Continue this series of minor corrections and again until all the bars are bent on back in to love. If the metal hollow tubes, ie new set of this exercise is ballhgame "as the tube is almost impossipbe restore.
Iron Yard
